EKF - Short Profile EKF - Short Profile


CC7-JAZZ

3U, CompactPCI  Pentium III Tualatin CPU
HTML documents available here
Description Product description in English
CC7-JAZZ - the Ultimate CPU
PDF documents available here
Product Information Product information in PDF format - English
Produktinformation Produktinformation im PDF-Format - Deutsch
"Darf es etwas mehr sein" PDF Dokument, CC7-JAZZ Fachartikel 'Darf es etwas mehr sein', Deutsch
User Guide PDF Document, CC7-JAZZ User Guide, English
Self Executable Slide Show (Win9x/NT), Major Benefits of CC7-JAZZ, English
Major Benefits Slide Show Self Executable Slide Show (Win9x/NT), Major Benefits of CC7-JAZZ, English
Download area for drivers Update: Embedded BIOS 2000
Update: Phoenix BIOS
Embedded Graphics Drivers (WXP)
Embedded Graphics Drivers (W2k)
Ethernet - Intel Drivers
Ethernet - Crynwr Open Source Package Driver
SMB Monitor (EXE)
CPU ID & Clock (EXE)
Subscription of the EKF NewsFlash, an E-Mail Letter with Announcements of Firmware and BIOS Updates
E-Mail on BIOS Update Subscription of the EKF NewsFlash, an E-Mail Letter with Announcements of Firmware and BIOS Updates, English
E-Mail bei BIOS Update Abonnement EKF NewsFlash, ein E-Mail Dienst mit Ankündigungen neuer Firmware/BIOS Updates, Deutsch
Download a photo in print quality Photo Gallery
1 | 2 | 3
Print Quality, 300dpi
10x15cm  ~0.35MB .JPG


CC7-JAZZ

CompactPCI  Pentium III Tualatin CPU
Compact Flash, Gigabit Ethernet and DVI-I Graphics on-Board


Alternatively equipped with the Intel 0.13u Tualatin-Celeron® or -Pentium III® 1.26GHz processor, the CC7-JAZZ is a powerful 3U (single size Eurocard) CPU board, well suited for any CompactPCI® system.

The board is provided with the chipset 815G which contains an embedded graphics controller. The DVI-I interface allows for attachment of both advanced (digital) and legacy (analog) flat panel displays and CRT monitors. The on-board USB port is the universal interface to a variety of peripheral devices. For high speed networking, the CC7-JAZZ is equipped with a 1000Mbps Gigabit Ethernet twisted pair jack. All connectors mentioned above are easily accessible from the cards front panel.



The CC7-JAZZ is equipped with an Ultra ATA/66 connector for mass storage devices such as IDE hard disks and CD-ROM drives. A receptacle for CompactFlash cards enables the use of silicon disks. The main memory is a SO-DIMM 144 form factor module. The jumperless board can be used with a FSB and memory clock speed of up to 133MHz.

Equipped with a PCI-bridge chip, the CC7-JAZZ offers a full CPCI interface for reliable system expansion. Especially designed for embedded systems applications, the General Software BIOS source code is maintained by EKF. This ensures custom specific enhancements are possible at any time.


CC7-JAZZ - the Ultimate Pentium III CPU Board

CC7-JAZZ - 3U Pentium III CPU
Feature Summary CC7-JAZZ
Form Factor CompactPCI Single size CompactPCI style Eurocard (160x100mm2), front panel width 4HP (20.3mm)
Processor Designed for Intel® CeleronTM, Pentium® III processors (restricted to Tualatin 0.13u processor generation)
Chipset i815G chip set consisting of:
  • 82815G Graphics/Memory Controller Hub (GMCH)
  • 82801 I/O Controller Hub (ICH)
  • 82802 Firmware Hub (FWH)
Memory
  • 144-pin SO-DIMM socket, module height 1.15" (30mm) max.
  • Support for up to 512MB, PC133, non ECC, unbuffered SDRAM
  • Support for serial presence detect (SPD) and non-SPD SO-DIMMs
Video I/O PanelLink Digital Technology Analog monitor and digital flat-panel display support by DVI-I connector (front panel), up to 1280x1024 pixel 16M colors 85Hz refresh rate, incorporates PanelLink Digital technology (Silicon Image)
USB I/O Single type A connector (front panel), USB1.1, data transfer rate of up to 12Mbit/s
Ethernet I/O 10/100/1000Mbps Gigabit Ethernet controller, 82540 chip, RJ-45 connector available from the front panel
Legacy I/O LPC Super-I/O interface connector, CC6-ACID companion board with Super-I/O controller available
IDE/ATA
  • Ultra ATA/66 40-pin connector (primary IDE)
  • CompactFlash socket for CFA ATA cards (secondary IDE)
CompactPCI  32-bit, 33.3MHz, PCI bridge chip Texas Instruments PCI2050, 133MBps CPCI master
BIOS General Software Embedded 2000 BIOS, 2..8Mbit Flash Memory
subject to change
CC7-JAZZ - Block Diagram

CC7-JAZZ - Block Diagram

Available as a companion board to the CC7-JAZZ, the CC6-ACID is provided with several legacy I/O ports. This module can be mounted either to the bottom side or on top of the CC7-JAZZ and communicates across the LPC (Low Pin Count) interface. The CC6-ACID will be required only if the classical interfaces, e.g. serial and parallel port remain in use in a given application.



As an option, the CC6-ACID can be delivered with an on-board 2.5" hard disk drive, resulting in a very compact system. The connectors COM1/2, LPT, mouse and keyboard are situated at the front panel (4HP and 8HP versions available), while an external floppy disk drive can be attached via the on-board pin header.


CC7-JAZZ - Component Assembly

CC7-JAZZ - Component Assembly (Top View)
Ordering Information
Alias Ordering No. Short Description
JAZZ CC7-1-JAZZ 3U CompactPCI Celeron 1.2GHz Tualatin CPU, 256MB SDRAM, 256KB cache, 100MHz FSB
JAZZ CC7-2-JAZZ 3U CompactPCI Pentium III 1.26GHz Tualatin CPU, 256MB SDRAM, 512kB cache, 133MHz FSB
  CC7-8-JAZZ 512MB SDRAM Option
ACID CC6-1-ACID 3U CompactPCI Super-I/O module, local expansion board complementing the CC7-JAZZ, front panel width 8HP, mounting on top of the CC7-JAZZ
ACID CC6-3-ACID Similar to the CC6-1-ACID, front panel width 4HP, w/o parallel port, mouse/keyboard combined in one Mini-DIN connector (external splitter cable available as accessory), mounting on the top or bottom side of the CC7-JAZZ
  CC6-8-HDK Optional hard disk drive, on-board mounting on top of the CC6-1 and CC6-3
  CR9-1-ADAPT mechanical kit, expands the CC7 front panel to 6U full height
  280.7.400 external keyboard/mouse Y-splitter-cable Mini-DIN male to 2 x Mini-DIN female (required for CC6-3 only)
  908.51.02.01 DVI-D to DVI-D cable assembly, 2m, connects the CC7-JAZZ to DVI monitors (digital way)
  908.57.02.01 DVI-I to HD DSUB15 cable assembly, 2m, connects the CC7-JAZZ to VGA monitors (analog way)
  908.57.12.01 DVI-I to VGA adapter (plug to receptacle), to be plugged onto the CC7-JAZZ DVI output, with HD DSUB15 socket, suitable especially for analog monitors with attached VGA cable
EKF is an ISO-9001 certified company
EKF Elektronik GmbH • Philipp-Reis-Str. 4 • 59065 Hamm • Germany
Phone +49 (0)2381/6890-0 • Fax +49 (0)2381/6890-90 • E-Mail